Home > Accessories > O-rings > K-20 K220
K-20 K-220 O-rings. These pumps use 6 O-rings total.

For the High Volume Stage (Outer Pump).

The Larger 2.5" diameter o-ring (part # 6331) goes on the plunger end and creates the air seal. This o-ring requires light lubrication. The other 2 o-rings are the same size/part number. These 2" diameter o-rings (part # 6326) act as cushions or cap seals. One can be seen from the outside of the pump and acts as a bumper/cap seal on the down-stroke and the other is inside the pump on the plunger shaft and acts as a bumper on the up-stroke.


For the High Pressure Stage (Inner Pump).


The Larger 1.5" diameter o-rings are (part # 6320). One goes on the plunger end and creates the air seal. This o-ring requires light lubrication. The other 1.5" o-ring is located at the top of the plunger shaft under the pump handle and seals the pump when locked. This o-ring can been seen from the outside of the pump. The smaller approx. 1.25" o-ring (part # 6215) is located on the plunger shaft and acts as a cushion or bumper on the upstroke.
Sort By:
Page of 1
K-Pump 2.5" Blue Cushion O-ring K-Pump 1.25" Cushion O-ring

K-Pump 1.25 replacement o-ring

Our Price: $2.50
K-Pump Blue Cushion O-ring K-200 K-Pump 1.5" Plunger/Cushion O-ring

K-Pump 1.5" replacement o-ring

Our Price: $2.50
K-Pump 2.0" Blue Cushion O-ring K-Pump 2.0" Cushion O-ring

2.0" replacement o-ring.

Our Price: $3.00
K-Pump Blue Cushion O-ring K-100 K-Pump 2.5" Plunger O-ring

2.5" replacement o-ring

Our Price: $3.50